Our Freedom I and Freedom II PMGs have a smooth and easy rotation! We've designed technology into our internal parts to get your wind turbine, hydroelectric, and motor mounted Freedom Series PMGs to start-up easier and make more power!
Our Freedom II HYDRO PMG™ permanent magnet generator is specifically designed for hydro or gas engine use.
Produces 12 volts at approximately 266 RPM
24 volts at 500 RPM
48 volts at 900 RPM
No resistance will be encountered until you reach the RPMs needed to exceed your battery voltage, making our Hydro PMG a powerful 12, 24, and 48 volt charger.
Why buy a Freedom or Freedom II PMG™ over a Delco car alternator PMA?
The answer is simply more copper! More copper equals more power - each Freedom PMG stator contains twice as much copper than any Delco style PMA.
Additional reasons why the Freedom PMG is better than ANY Delco or other modified car alternator PMA:
Some modified alternators use power to make power. Freedom PMGs use no input power.
PMAs use a thin aluminum housing and the stator is not pressed in. The Freedom PMG features a very thick aluminum housing and a pressed in stator that helps with proper alignment and durability.
PMAs have only two mounting holes. The Freedom PMG has four of them bolted tightly against the mounting bracket for secure mounting.
Alternators and some PMAs have a weak rear bearing. The Freedom PMG utilizes two heavy duty bearings.
Most car alternators and PMAs that are repurposed use low grade/high iron electrical steel which can create a lot of heat. The Freedom PMG uses high grade electrical steel and is optimized for efficient cooling
NO COGGING, easy to turn
Comes with two heavy duty rectifiers & one hub spacer stabilizer
Includes fan and 80 mm double pulley
Skewed stator core with high grade electrical steel and heavy duty copper windings
17 mm stainless steel shaft compatible with all Missouri Wind and Solar hubs
2x thick polished aluminum case
Zinc plated 28 rare earth neodymium magnet rotor
For charging 12 volt battery banks
Fits delco bolt patterns and mounts up to our standard mounting bracket.
3/8" diameter bolt holes
1 15/16" on center between mounting holes
5 7/8" OD width
6 5/16" tall
9 1/2" overall length
Shaft thread & size: M16 - 1.5 (M=metric, 1.5 = metric thread pitch)
Freedom II Output with the MidNite Classic Charge Controller:
|Voltage||: 12 Volts or 24 Volts or 48 Volts|