For 12 or 48 Volt Battery Charging
Tail Design for Higher Winds & Faster Tracking
Start-up wind speed between 8 - 12 mph
ULTRA HIGH SPEED RAPTOR GENERATION 4 WIND TURBINE BLADES
Uses: Battery or battery bank charging, stackable wind turbine grid tie inverters, direct DC water heating elements, direct DC resistive heating, or other applications where 3 phase AC or DC can be used.
What you get with the 500 Watt Wind Turbine:
3, 5, or 7 Raptor Generation 4 Wind Turbine Blades for maximum output
Assembled blades are 60" diameter
Blades do not overload the PMA at low RPMs, turns faster for more amps
Wind Turbine Blade Hub
3/16'' thick steel, no cheap aluminum or plastic
500 Watt Permanent Magnet Alternator
Standard 17 mm shaft
100% solid core zinc plated rotor design with air flow holes for cooler operation
Smoother operation with flywheel power boost
Housing bolts treated with anti-seize to prevent dissimilar metal corrosion
Above 500 watts if you have zone 2 winds or above; power rated when using Raptor G4™ blades. Easy start-up in zone 2 winds or higher depending on blade set.
125,000 hours+ of rated bearing life. New bearings cost only $3.00
AC Output Models: The 3 phase AC to DC bridge rectifier can be installed next to your batteries or inverter for a 3 phase cable run down the tower.
DC Output Models: The 3 phase AC to DC bridge rectifier is built into the case making it a two wire run to your charge controller or batteries.
Tail Fin & Arms
16 gauge steel
Measures 13 x 19 Inches
Double tail arms
*Requires painting to resist rust
Steel mounting bracket
Fits on 1.5" schedule #40 or #80 pipe
Limited Warranty
Copyright © MWANDS.COM, LLC..