0 ít
Freedom PMG™ Permanent Magnet Generator


321.99 321.99 USD

321.99

This combination does not exist.


Missouri Wind and Solar FREEDOM PMG™
(permanent magnet generator)

 with Optional Marine Coating*
 
 

NEW for June 2018: Our Freedom I and Freedom II PMGs are now designed with a keyed shaft and hub stabilizer as well as includes a self-tightening cam-lock washer to prevent the blade set from ever spinning on the shaft. 

Operating Information:

  1. Produces battery voltage at approximately 266 RPM
  2. Produces twice (2X) the battery voltage at approximately 506 RPM
  3. Produces four times (4X) the battery voltage at approximately 960 RPM

Not for hydro, gas engine, electric motor coupled use. For wind turbine use only. See our Hydro PMG for these applications.

Why buy a Freedom or Freedom II PMG™ over a Delco car alternator PMA?

The answer is simply more copper!  More copper equals more power - each Freedom PMG stator contains twice as much copper than any Delco style PMA. 

Additional reasons why the Freedom PMG is better than ANY Delco or other modified car alternator PMA:

  • Some modified alternators use power to make power.  Freedom PMGs use no input power.
  • PMAs use a thin aluminum housing and the stator is not pressed in.  The Freedom PMG features a very thick aluminum housing and a pressed in stator that helps with proper alignment and durability.
  • PMAs have only two mounting holes.  The Freedom PMG has four of them bolted tightly against the mounting bracket for secure mounting.
  • Alternators and some PMAs have a weak rear bearing.  The Freedom PMG utilizes two heavy duty bearings.
  • Most car alternators and PMAs that are repurposed use low grade/high iron electrical steel which can create a lot of heat.  The Freedom PMG uses high grade electrical steel and is optimized for efficient cooling

PMG Features: 

  • NO COGGING, easy to turn - Cut in speed of 6 MPH
  • Skewed stator core with high grade electrical steel and heavy duty copper windings
  • 17 mm stainless steel shaft compatible with all Missouri Wind and Solar hubs
  • 2x thick polished aluminum case
  • Zinc plated 14 rare earth neodymium magnet rotor
  • No brushes to fail or replace
  • Two heavy duty bearings in front and back
  • Fits delco bolt patterns and mounts up to our standard mounting bracket
  • Comes with bridge rectifier

PMG Specifications:

  • 3/8" Diameter bolt holes
  • 1 15/16" on center between mounting holes
  • 5 7/8" OD Width
  • 6 5/16" Tall
  • 5.5" Total Length
  • Shaft thread & size: M16 - 1.5 (M=metric, 1.5 = metric thread pitch)
*Optional Marine Finish:

Saltwater environments will cause the internal components to rust over time.  Our marine varnish service includes disassembling the motor and coating the interior. As our sold-separately PMA Coating can only ship by ground service and is restricted in some countries, Missouri Wind and Solar is offering an add-on service to coat the internal components before shipping.  Prolong the life of your Freedom PMG by protecting it from the effects of saltwater environments.  Please allow additional handling time when choosing this service.


Missouri Wind and Solar Permanent Magnet Generator PMG

Make sure you also check out our Freedom II PMG™!


Wind Turbine Testing


Missouri Freedom PMG Power Curve Chart

Specifications for " Freedom PMG™ Permanent Magnet Generator "

Voltage : 12 Volts or 24 Volts or 48 Volts
You can compare max 4 products.