Raptor G5 Wind Turbine Blade Assembly

Raptor G5 Wind Turbine Blade Assembly

The image below illustrates the Raptor G5 Wind Turbine Blade Assembly.  Please be sure to read all of the notes below to ensure you have installed them in the correct direction.

All Raptor G5 Wind Turbine blades have a flat side that must face the wind. The “G5” stamp that is near the bolt holes will face AGAINST the hub and the “notch” at the blade base will be on the right side if installed correctly. Only tighten the blade bolts to 10 pounds of torque or the blade handles may crack. Use the provided self locking nuts or the blades may come loose.

The blades are flexible and they may arrive with a slight bend. If this is the case, install them as they will self-straighten in the wind within a couple of weeks and remain straight permanently.

The Raptor G5 wind turbine hubs are zinc plated to resist rust and do not require painting. The wind turbine blades have a 25 year UV protectant and do not require painting.

WARNING: The Raptor G5 blades turn very fast and can cause severe bodily damage if you come into contact with them. Never place a wind turbine near power lines or structures. Place wind turbine high enough to be out of reach of children and inexperienced persons. Missouri Wind and Solar, LLC assumes no liability for injury or damage caused by these blades.

For our full line of Raptor Generation 5 wind turbines, click here.

Raptor Generation 5 Wind Turbine Blade Assembly

Click image to enlarge

For more information about our Raptor Generation 5 Blades, watch the video below

Comments are closed.