This divert load resistor is for use to divert the excess power being generated when your wind turbine generator batteries are full and can be ran at 100% duty cycle due to the quality rib wound design. It can also be used with a solar array in diversion mode.
Diversion dump loads are very important to have with a wind turbine to keep it from free spinning. The unit can be used alone to provide free heat as well by hooking your turbine or solar panels directly to it. For an alternative dump load see our DC water heating elements to get FREE hot water from solar, hydroelectric, or wind power. The divert load comes completely assembled for easy installation.
Important note about wire gauge for this resistor bank when used with a relay: use 1 gauge cable for connections to the relay. Undersized wiring will cause heat buildup and cause the relay to fail prematurely.
You need to divert the excess power being generated to a load so your wind turbine generators will NOT go into high speed freewheeling in heavy winds.
Dimensions:
Watch our video below to understand why a dump load is necessary, especially for a wind turbine.
Copyright © MWANDS.COM, LLC..