PMA & PMG Parts & Components
Product Compare (0)
Basic Permanent Magnet Alternator Rotor for Making Your Own DIY Wind Turbine PMA Used for making a PMA (permanent magnet alternator) for horizontal ..
Blank Stator Core 10-12SIBlank stator core with insulation installed. Just add wire for your custom stator or rewind project. Use to wind an alternato..
Custom Heavy Duty 3 Phase Jack with Hardware This is the same heavy duty harness we use on our PMAs. This wiring harness makes a great quick con..
Delco 10/SI PMA Case with BearingsOur PMA case comes with 4 bolts and heavy duty front and rear bearings. A perfect match for all Missouri Wind PMA pa..
Double Pulley for 1/2 Inch BeltsPulley Specifications: For permanent magnet alternators with 17mm shaft Pulley fits 1/2" belts If you have a pr..
Fan and 80 mm Double Pulley For Permanent Magnet Generators/AlternatorsA large extra heavy duty cooling fan must be used for all engine, hydro, and or..
Fan and Single Pulley For Permanent Magnet Generators/AlternatorA large extra heavy duty cooling fan must be used for all engine, hydro, and or belt d..
Front Bearing for Permanent Magnet AlternatorThis front bearing is for building your own permanent magnet alternator (PMA) or as a replacement part fo..
L-Flux 14 Magnet Rotor for Permanent Magnet Alternators Ideal for making a PMA (permanent magnet alternator) with a Delco 10si or 12si alternator. D..
Permanent Magnet Alternator Stator CoilPlease choose before adding to cart between: Hydro (12v), 12 volt, 24 volt, 48 volt. If you are using a sta..
Rotor Shaft For Permanent Magnet AlternatorThis rotor shaft fits Delco 10SI/12SI alternator. Perfect for building your own Permanent Magnet Alternator..
Single Pulley for 1/2 Inch BeltsSizes: 2 3/8" (2.36"), 60MM OD pulley for wide 1/2" belts 3 1/8" (3.14"), 80MM OD pulley for wide 1/2" belts ..
Permanent Magnet Alternator & Permanent Magnet Generator Wind Turbine Coating PMA COATING cannot be found on store shelves simply because it cont..
Showing 1 to 13 of 13 (1 Pages)