Raptor G5 Wind Turbine Blade Assembly

Raptor G5 Wind Turbine Blade Assembly

Raptor G5 Blade Assembly

All Raptor G5 blades have a flat side that must face the wind. The "G5" stamp that is near the bolt holes will face AGAINST the hub. Only tighten the blade bolts to 5 pounds of torque or the blade handles may crack. Use the provided self locking nuts or the blades may come loose. The blades are flexible and they may arrive with a slight bend. If this is the case, install them as they will self-straighten in the wind within a couple of weeks and remain straight permanently.

If the hub is not zinc plated, paint it to prevent rust, making sure to use a metal primer. WARNING: The Raptor G5 blades turn very fast and can cause severe bodily damage if you come into contact with them. Never place a wind turbine near power lines or structures. Place wind turbine high enough to be out of reach of children and inexperienced persons. Missouri Wind and Solar, LLC assumes no liability for injury or damage caused by these blades.