Free shipping on hundreds of products

Fan and Single Pulley For Permanent Magnet Generators/Alternator


A large extra heavy duty cooling fan must be used for all engine, hydro, and or belt driven systems including vertical axis wind turbine applications. Wind turbines usually have enough air circulation not to require a fan but you must determine this fact by testing and observation as each project has unique characteristics.

Notched v-belts run cooler and do not slip as much. A slipping belt can cause bearing stress and heat buildup in the PMA. Read the heat warnings below.

The fan and pulley come in two sizes:

  • 2 3/8 inch, 60mm OD pulley for wide 1/2 inch belts
  • 3 1/8 inch, 80mm OD pulley for wide 1/2 inch belts

Specify your cooling fan kit option at the time of your PMA order.

Heat warnings: Proper installation is very important when it comes to getting maximum life and efficiency from your v-belts. Take time to insure that your pulleys are properly lined up with a straight edge and that they are not worn and cutting into the v-belts. Proper v-belt tension should be set with a v-belt tension tool and reset again after the first week or so of operation to allow for stretching. Most of the stretching takes place in the first hours of operation so it is very important to re-check belt tension after the belt has had some run time.

If you are pulling over 500 Watts (in a non-wind turbine installation) without a cooling fan, your PMA may overheat! Fan kits are very important to have on ALL high amp applications! Keeping your PMAs cooled, fused and under reasonable loads is the operator's full responsibility. Monitor your PMA for excessive heat production in all experimental machinery! The maximum PMA operating temperature is 350 degrees F. for 100% duty cycle. No warranties on ANY burned out PMAs! They are sold in good working condition, it is the customer's responsibility to keep them cool and never overloaded in regard to amperage draw.

Our PMAs are not fail safe! If you overload them they can burn out. You, as the designer, must watch carefully for signs of overheating. We will not warranty any fried PMAs!

Write a review

Please login or register to review

Fan and Single Pulley For Permanent Magnet Generators/Alternators

  • Product Code: 362
  • Availability: In Stock
  • $28.99

Available options

Related Products

Freedom PMG™ Permanent Magnet Generator

Missouri Wind and Solar FREEDOM PMG™ (permanent magnet generator) with Optional Marine Coating*  NEW..


Freedom II PMG™ Permanent Magnet Generator

Freedom II PMG™ Permanent Magnet Generator with Optional Marine Coating*   Our newest innovation in..


Freedom Hydro PMG™ Permanent Magnet Generator

Missouri Wind and Solar Freedom Hydroelectric PMG™(permanent magnet generator)Specifically designed ..


Freedom II Hydro PMG™ Permanent Magnet Generator

Missouri Wind and Solar Freedom II Hydroelectric PMG™ (permanent magnet generator)  Up to 2800..


7 Magnet AC Output Permanent Magnet Alternator for Wind Turbines

Permanent Magnet Alternator with Neodymium Magnet Rotor3 phase output - DC output after the included..


Permanent Magnet Alternator Stator Coil

Permanent Magnet Alternator Stator CoilPlease choose before adding to cart between: Hydro (12v), 12..


L-Flux 14 Magnet Permanent Magnet Alternator Rotor

L-Flux 14 Magnet Rotor for Permanent Magnet Alternators Ideal for making a PMA (permanent magnet al..


Single Pulley for 1/2 Inch Belts

Single Pulley for 1/2 Inch BeltsSizes: 2 3/8" (2.36"), 60MM OD pulley for wide 1/2" belts 3 1/..


Tags: hydro, fan, pulley